Home / Contact

Contact and inquiry

To size a pulsation damper, pulsmin needs details of the compressor: type, intake volume flow, operating pressure and operating temperature. The bypass bore and damping disc are sized individually for every application. For the pulsation dampening disc PDS there is a separate questionnaire.

Address

pulsmin · Hansjakob Lütte
Seelhofstraße 24
79539 Lörrach, Germany

Request sizing

PDV and PDV-DS pulsation dampers

1 Preselect a PDV

Guide values from the dimension sheet. The preselection is carried over into the inquiry.

Compressor type
Intake volume flow at maximum speed
l/min
Matching valve

PDV G 1"

Pulsation damper for screw and rotary vane compressors

Connection
G 1"
Overall length
67 mm
Width across flats
41 mm
Weight
0.50 kg

Guide values from the dimension sheet. pulsmin finalises every design.

2 Operating data and contact

The inquiry goes straight to pulsmin. No data is stored on this website.

Preselection: PDV G 1" for 2,100 l/min

Operating data for sizing
bar
°C
°C

The inquiry goes straight to pulsmin.

PDS pulsation dampening disc

1 Preselect a pulsation dampening disc

Pulsation dampening disc PDS

So that we can design your pulsation dampening disc (PDS) optimally for your system, we need some information on the medium, operating conditions and piping. Please fill in the following data as completely as possible. If your system runs at two different speeds or volume flows, please state both operating points.

Why do we need this information?

The PDS is not a broadband damper; it is designed specifically for the existing operating conditions and pulsation frequencies. That is why volume flow, pressure, temperature, pulsation frequency and the piping geometry in particular are decisive for optimal performance.

The more accurate the information, the more precisely damping effect and pressure loss of the PDS can be matched to your application.

You do not have all the data at hand? No problem.

Send us the information you have – together we will check which further details are needed for the design.

Questionnaire as PDF (German) PDF · 262 KB

2 Questionnaire for the design of a pulsation dampening disc (PDS)

The questionnaire goes straight to pulsmin. No data is stored on this website.

1. Medium and operating conditions
Which gas is compressed?
°C
Gas temperature at the compressor inlet
bar(g)
Operating gauge pressure
°C
Gas temperature directly upstream of the PDS
bar
Pressure fluctuation, peak-to-peak value
2. Volume flow and pulsation frequency

Operating point 1

Nm³/h
Volume flow of the system
Hz
Frequency of the gas discharges

For a single-cylinder compressor, the pulsation frequency usually equals the compressor speed.

Operating point 2 – optional

Nm³/h
Volume flow at the second speed
Hz
Frequency of the gas discharges at the second speed

If the system runs at one speed only, C2 is not required.

3. Piping

The piping conditions upstream and downstream of the PDS also matter for the design.

mm
Free inside diameter of the pipe
m
Length of pipe from the compressor to the PDS
mm
Free inside diameter of the pipe
m
Length of pipe from the PDS to the next relevant component or the pipe end
Contact

The questionnaire goes straight to pulsmin. No data is stored on this website.